2007 Gefco Speedstar 30k Drill Rig

Product Description

Truck:

2007 model Peterbilt Model 357 (6x4) truck with CAT model C-15 engine rated at 550hp or equal, 22,000 lb front axle, 46,000 lb. rear tandem axle, Fuller 18 speed transmission, 2 fuel tanks 70 and 150 gallon, air conditioning, jake brake, Alcoa aluminum wheels.

Miles on truck- 63,863

Four (4) hydraulic leveling jacks

Tophead drive, 70,000 in-lbs torque, 0-120 RPM, 2 11/16” water/air course

Hydraulic jib boom with dual controls, driller and helper side

Carousel to hold 6 pieces of 4 ½” x 20’ drill rod with 2 7/8” IF tool joint with top breakout wrench

Hydraulic cylinder with cable pull down hold back 25,000 lb pulldown, 30,000 lb holdback

Main winch over jib boom, 25,000 lb single line pull with ¾” cable and jib fully collapsed, 2,200 lb capacity with jib extended

Line oiler for hammer drilling

Hydraulic powered water injection pump, 18 GPM Bean, 4 cylinder

Single rod loader, helper side for loading drill rod under tophead (for 4 ½” x 20’, 2 7/8” IF rod)

Hydraulic powered, split table guide, with air operated holding wrench, closed table without bushing has 11” hole

Hydraulic powered 60” pipe breakout wrench

Hydraulic rod spinner

Mission Magnum 4x3 mud pump, hydraulic drive controls, and 2 ½” piping

Aux winch

Angled pipe rack for 15 pieces of pipe

PTO for compressor and hydraulic pump drive, w/clutch

1000 cfm @ 350 psi screw air compressor

Standard 2 ½” air and mud piping

Drill platforms, driller and helper