Product Description
2000 Ingersoll Rand TH-60 Water Well/ Geothermal Drill Rig
Mounted on 2000 International Paystar 5000
Cat 3406 engine with 3-position exhaust brake
10 speed Spicer trans
400,000 miles on speedo - 6,750 miles on hub odo
Drill rig specs
11,490 hrs
30 K pullback
825/350 IR air compressor - 2,560 hrs
38' tower with 6 piece carousel (4 ~ inch pipe)
2 speed top head
18 k hoisting line
3 k sand line with 880' of 3/8" cable
Mission Sandmaster 3x4 centrifugal mud pump
25 GPM Cat injection pump w/ foam injection regulation
DHD oiler - 3 CFM settings
set up to run 4 ~" pipe with 2 7/8 IF thread
This drill has a mud pump for mud drilling applications!
Notable repairs/reconditioning
4/07 new rotation pump
5/07 new top head drive motors
7/07 new drive motor on mud pump
9/08 CM25 swivel rebuilt by Atlas Copco
1/09 upgraded table clamp bar to T3W style
1/09 rebuilt main multi stage hydraulic pump
2/09 rebuilt sand line winch hydraulic motor
8/09 top head drive gearbox rebuilt and new stinger installed by Atlas Copco
8/09 replaced all 2 ~" air/mud plumbing
4/10 new full exhaust system from turbo out including muffler and all pipe
7/10 replaced rotation charge pump and upgraded to 3 cubic inch
7/10 new holdback cables
7/10 wet end rebuilt with all Mission parts
8/10 new upper top head drive seal
General overall rig condition
rig has been actively drilling since new and is mechanically sound
rig has performed approximately 80% fluid and 20% air drilling
interior is in good condition
tires are approximately 50 % tread
paint on cab is in fair condition
paint on rig is in poor condition
Well maintained drill rig suitable for geothermal or water well drilling. The TH-60 runs off the truck engine, eliminating the need for a deck engine on drill, allowing you more space for adding a mud pump, or just more deck room to move around the drill rig
